We are engaged in offering excellent quality Hydraulic Turret Busbar Processing Machine to our valuable clients. The hydraulic turret busbar processing machine is mainly used for different types of processing of copper or aluminum busbar.It is easy to operate and high production efficiency. So it is an ideal processing equipment for electrical appliance manufacture of high and low voltage. There are four foot-wheels to move easily.
It has three units : punching, shearing and bending
Punching unit:1.united six-mode turnplate in tooth shape, make sure the upper mold and the lower mold are absolutely in the center.
2.6 punching dies can punching 6 kinds of holes without stopping to change the dies
3.Three location modes: locating pin,caliper and light.
4.No pressing mark on the workpiece surface.
5.Can punching non-standard holes,for example, square hole, oval hole,etc.
Shearing unit: 1.use sharp shearing. flat incision interface, no droop and burrs and waste.
2.Two pressure plates to make sure no apex angle.
3. 2 limit switches
Bending unit: 1.2 sets of bending dies.
2. Horizental bending.(2 sets bending dies)
3.Vertical bending( 2 sets bending dies)
4.2 sets of embossing dies
Clients can avail this Hydraulic Turret Busbar Processing Machine at industry leading prices from us.